Configuring An Aperio Door Controller Panel - Mircom TX3 Series Installation And Operation Manual

4.
5.
6.
7.
8.
9.
10.
11.
12.
The job tree in your TX3 Configurator should be populated with all of the panels
in your TX3 system. Disconnecting from the system is necessary in order to be
able to configure your Aperio Door Controller panels. You cannot configure
your TX3 system while you are connected to it.
3.1.2

Configuring an Aperio Door Controller Panel

Use the TX3 Configurator to set options for your Aperio Door Controller panel.
Configuration options include setting the RS-485 address for the Aperio Door
Controller panel as well as the types of cards that the panel can read.
To configure a panel
1.
TX3 Aperio Door Controller System Installation and Operation Manual
70
LT-1160 Copyright 2019
Click Network in the job tree.
In the Network Configuration window, select the type of connection you
made in step 1 from the PC connection list (that is, select either USB
or TCP/IP).
From the menu bar, click Panels > Connect.
Click File > New Job.
Enter a name for the job in the Job name text box.
(Optional) Enter a description for the job in the Description text box.
Select Create by reading panels on the network.
Click OK.
The TX3 Configurator connects to each of the panels to create the job.
This may take a few minutes, especially if you have a large number of
panels in your TX3 system.
From the menu bar, click Panels > Disconnect.
Select an Aperio Door Controller panel in your job tree.
Configuration
v. 1.6