Enabling Remote Open - Mircom TX3 Series Installation And Operation Manual

8.
9.
2.7.4

Enabling Remote Open

Wireless devices can be configured to support remote unlocking from either the
TX3 Configurator monitor or during an auto-unlock schedule. When you set the
unlock mode to ON in the TX3 Configurator monitor, the Aperio wireless device
unlocks and stays unlocked until you set the unlock mode to OFF. When an auto-
unlock schedule is configured, the wireless device unlocks at the beginning of
the auto-unlock schedule and then returns to locked mode at the end of the
schedule.
To configure a wireless device to support remote unlocking, you must first
enable the advanced options for the Aperio Programming Application and then
you must configure each device to support the Remote Open option.
2.7.4.1 Enabling Advanced Options in the Aperio Programming Application
To enable advanced options in the Aperio Programming Application
1.
2.
3.
4.
5.
You now have access to the advanced configuration options.
2.7.4.2 Configuring an Aperio Hub to Support Remote Open
To configure an Aperio hub to support Remote Open
1.
2.
3.
TX3 Aperio Door Controller System Installation and Operation Manual
v. 1.6
LT-1160 Copyright 2019
Swipe an access card at the device.
Click Close to return to the Aperio Programming Application window.
Click Settings > User Settings.
Select Show advanced settings.
Click OK to close the Message window.
Click OK to close the User Settings window.
Restart the Aperio Programming Application and then log in to your
installation.
Right-click on the Aperio hub, and then select either Configure or
Communication Hub > Configure.
Click Next until you reach the Electronic Access Controller
Settings page.
In the Remote Open section, click Change.
Installation and Setup
49