Turning On The Controller; Default Configuration Values; Updating Firmware - Mircom TX3 Series Installation And Operation Manual

JW3 and JW4. JW3 and JW4 are not used and are open by default.
JW5. JW5 is open by default. On boards with the model number MD-10xx, you
can close JW5 on the first and last controllers instead of using end-of-line 120 Ω
resistors for RS-485.
JW7 and JW8. If there are problems with RS-485 communication, close both
JW7 and JW8 on either the first or last controller connected by RS-485. By
default, JW7 and JW8 are open.
2.10

Turning on the Controller

Before you turn on the controller, ensure that the all connections adhere with the
correct operation of the devices.
Once the controller is turned on, you must begin the configuration. Basic
configuration settings for the Aperio Door Controller are covered in Chapter 3
Configuration. For detailed information on how to configure the controller and
other TX3 devices, see LT-995 Configuration and Administration Guide.
2.10.1

Default Configuration Values

Once the controller is on, it operates according to its preset default configuration
values. When the configurator software first starts, it uses the default values and
adopts these values as its initial settings.
The default configuration values are adopted only when the following situations
occur:
•
•
•
2.11

Updating Firmware

You can update the firmware on your panel with the TX3 Configurator software
by using one of the following methods.
•
•
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel.
TX3 Aperio Door Controller System Installation and Operation Manual
62
LT-1160 Copyright 2019
turning the system on for the first time
memory corruption
program upgrade
Firmware Upgrade Wizard
Network Firmware Upgrade
Installation and Setup
v. 1.6