Label; Assigned To; Active State; Circuit Supervision - Mircom TX3 Series Installation And Operation Manual

Inputs 1 to 8 in Figure 40 correspond to inputs 1 to 8 on the Aperio Door
Controller panel. If you connected inputs to your Aperio Door Controller panel
(see section 2.4, Connecting the Inputs, on page 24), you must enter the
information regarding these inputs into the TX3 Configurator. If the information
is not entered into the TX3 Configurator, the panel will not be able to monitor the
inputs properly.
The following options can be entered for each input:
•
•
•
•
•
These options are explained in more detail in sections 3.6.1 to 3.6.5. Section
3.6.6 explains how to configure these options for an input.
3.6.1

Label

Use this option to provide a descriptive name for the input (for example, "Call
security button" or "Accessible door button").
3.6.2

Assigned to

This option is not configurable for Aperio Door Controller panels. All inputs are
general purpose inputs for these panels.
3.6.3

Active state

Select the active state of the input. The options available are:
•
•
3.6.4

Circuit supervision

Select the type of supervision used on the input. This must match the type of
circuit supervision installed with the input. The options available are:
•
•
•
•
TX3 Aperio Door Controller System Installation and Operation Manual
82
LT-1160 Copyright 2019
Label
Assigned to
Active state
Circuit supervision
Alarm delay
Open
Close
None
Open circuit
Short circuit
Open and short circuit
Configuration
v. 1.6