Report Not Initialized; Report Request To Exit; Report Unknown Format; Report Door Not Open - Mircom TX3 Series Installation And Operation Manual

3.5.8

Report Not Initialized

Wireless devices have sensors that should be initialized at the factory. If a
wireless device is not initialized, this is detected by the Aperio hub. Select this
option to have the Aperio Door Controller log and report wireless devices that are
not initialized.
3.5.9

Report request to exit

This option logs and monitors events and system status. When enabled any
requests to exit are logged and reported to the configurator. Since the person
exiting is not known, only the time and date and the request itself is logged and
reported.
3.5.10

Report unknown format

When enabled, this option logs and reports access attempts with a card with an
unknown format.
3.5.11

Report door not open

When enabled, this option logs and reports when access is granted but the door
remains closed.
3.5.12

Auto relock

This option does not apply to ASSA ABLOY devices.
3.5.13

RTE bypass DC

This option does not apply to ASSA ABLOY devices.
3.5.14

Disable forced entry alarm

Disabling the forced entry alarm will not activate the forced entry alarm even if
the door is opened without permission. Instead, an access granted sequence is
started. This is usually used on access points where there is no request to exit
(RTE) device.
3.5.15

Ignore card facility code

This option is enabled by default meaning that only the card number is processed.
If this option is unchecked both the card number and the facility code of the card
will be processed to grant access.
TX3 Aperio Door Controller System Installation and Operation Manual
80
LT-1160 Copyright 2019
Configuration
v. 1.6