Connecting The Outputs; Active State; Outputs 1 To 6 - Mircom TX3 Series Installation And Operation Manual

2.5

Connecting the Outputs

There are 8 general purpose outputs located on the top right hand corner of the
Aperio Door Controller as shown in Figure 7.
Each output is wired for a specific function or for an active state. Determine the
functional requirements for the device and connect the outputs accordingly. For
additional details and a complete description of the different types of
configurable functions, see section 3.7, Aperio Door Controller Outputs, on
page 83.
After the installation and setup is complete, the functional state of all outputs
must be configured using the TX3 Configurator software.
2.5.1

Active State

Outputs require active states. Each output is configured for the active state to
indicate one of the following:
•
•
2.5.2

Outputs 1 to 6

Outputs 1 to 6 are relay contact programmable outputs with the following
characteristics. Figure 16 shows a sample connection.
•
•
•
•
TX3 Aperio Door Controller System Installation and Operation Manual
28
LT-1160 Copyright 2019
Energized
De-energized
normally open (NO)
normally closed (NC) available
125 VAC / 2 A
30 VDC / 1 A
Installation and Setup
v. 1.6