Sending Your Configuration; Connecting To Your Tx3 System - Mircom TX3 Series Installation And Operation Manual

3.13

Sending Your Configuration

Configuration changes can only be made when you are not connected to your
TX3 system. Once you have finished setting your options in the TX3
Configurator, you must connect to your system and then send the job for the
configuration to be programmed into the panel(s) in your system.
3.13.1

Connecting to Your TX3 System

Connecting to your TX3 system establishes a communication link between your
PC and the panel(s) on your TX3 system. You must connect to the TX3 system in
order to send your job and monitor the panels in your system.
To connect to your panel(s), each panel must have the same level 3 passcode. By
default, this passcode is 3333. See LT-995 for more information about the
passcode and how to set it (if necessary).
To connect to your TX3 system
1.
2.
3.
TX3 Aperio Door Controller System Installation and Operation Manual
98
LT-1160 Copyright 2019
Establish a physical connection to either a panel or to the TCP/IP network
that your TX3 system is on. To determine the best type of physical
connection, note the following:
• If your TX3 system is either a single panel or more than one panel
connected on a single RS-485 network, you can connect by USB
connection to the USB connector on a panel, by connecting to the
COM port on a panel, or by dialling in to a panel using a modem on
your PC (the panel must have a modem card installed).
• If your TX3 system is on a TCP/IP network, connect your PC to the
TCP/IP network using an ethernet cable.
Click Network from the job tree.
Select the type of connection you are using from the PC Connection
list.
If you selected either COM Port or Modem, you must make the
following configuration settings:
COM Port: select the COM port number on your PC that your are using
to connect to the panel.
Modem: Enter the following parameters:
• Modem. Select a modem currently configured on your PC.
• Phone #. Provide the telephone number the panel is connected to. If
necessary use a comma for a pause.
Configuration
v. 1.6