Firmware Version Control - Mircom TX3 Series Installation And Operation Manual

To update firmware
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
2.9.1

Firmware Version Control

The firmware version number is accessible from the configurator software and
changes whenever there is a major, minor or revision update.
The following convention is used whenever there is a major, minor or revision
change:
Initial release. Version 1.00.0
Major change. Version 2.00.0
Minor change. Version 2.01.0
Revision changes. Version 2.01.1
Version 1.00.3 TX3-CX Card Access System Installation and Operation Manual
Copyright 2009
Turn the power OFF by using SW1 on the bottom right side of the card
access controller board.
Disconnect the battery.
Short JW1 and JW2 using a jumper.
Turn the power ON.
Wait for 15 seconds.
Turn power OFF and remove jumper JW2.
Connect the USB cable to the card access controller board.
Turn the power ON.
Proceed with the firmware update using the configurator software.
When you are finished updating the firmware, turn the power OFF.
Unplug the USB cable.
Open JW1.
Reconnect the battery.
Turn the power back ON.
Installation and Setup
33 (56)