Belt Position Adjustment - Roland SOLJET Pro III XC-540 Service Notes

REVISED 1

4-16 BELT POSITION ADJUSTMENT

This adjustment is to prevent the belt wear which is caused by the belt contacting with the pulley
flanges excessively. The belt position needs to be confirmed after the Belt Tension Adjustment and
adjusted if it is necessary.
Remove the 5 covers including a lever knob shown in
1
the figure.
Remove them in the following order.
1. FRONT RAIL COVER
2. TOP COVER
3. RIGHT I/S COVER
4. LOADING LEVER KNOB
5. RIGHT TOP COVER
Confirm that the Belt Tension Adjustment is completed
2
and turn on the Main Power switch.
(Referential Time : 30min.)
FRONT RAIL COVER
RIGHT TOP COVER
4-65
TOP COVER
RIGHT I/S COVER
LOADING LEVER KNOB