Roland SOLJET Pro III XC-540 Service Notes page 117

Replace to the new Carriage Belt.
9
Check that the Belt is not twisted.
Put adequate quantity of grease (P/# : 39008297•FLOIL
G902 14KG) between pulleys.
Tighten the Screws shown in the figure to fix both edges
10
of the Carriage Belt to the Belt Holder.
When fixing the Carriage Belt, make sure the
end of the Belt are not overlapped.
Revised 1
Be careful with fixing direction of the Plastic
Plate and fixing order of the Plates.
< Cross-section diagram >
OK)
Perform the followings to adjust the Pulley
11
Tighten the Screw shown in the figure until the Stay
1.
reaches to the Shaft.
Screw
Metal Plate
Plastic Plate
Belt Holder
Carriage Belt
< Cross-section diagram >
OK)
Plastic Plate
Carriage Belt
NG)
Plastic Plate
Carriage Belt
Plastic Plate
Carriage Belt
< Right side >
3-55
Screw
Plastic Plate
Metal Plate
Belt Holder
Screw
Plastic Plate
Metal Plate
Belt Holder
Screw
Plastic Plate
Metal Plate
Belt Holder
Stay
Screw
Shaft