Roland SOLJET Pro III XC-540 Service Notes page 125

Connect the new Flexible Cable to the Tool Carriage
13
Board. Then, fix the 2 new Protection Plate with putting
the Flexible Cable between them.
Be careful with the fixing direction of the
Flexible Cable.
Fix the Protection Plate on the Rail with the rivets.
14
Lead the Flexible Cable as shown in the figure, and
15
connect to CN13 on the Servo Board.
Connect the flexible Cable to the CN13 on the Servo
Board.
Turn over the board and
fix the Protection Plate
with the rivets.
3-63
Protection Plate
Protection Plate (Upper)
Protection Plate (Lower)