Roland SOLJET Pro III XC-540 Service Notes page 185

Three marks are printed at the left-end , right-end and the
7
center of the media, and each mark is cut. Confirm the
cut line positions on the marks visually.
When it is difficult to see the cut line visually,
use a magnifier.
Adjustment is completed if the position error of cut line is
8
within the range below. If not, select [SETTING] menu
again for further adjustment.
Mark on the right: Within +/-0.1mm
Mark on the left: Within +/-0.3mm
(Make adjustment based on the mark on the right)
key : Moves cut position towards front
key : Moves cut position towards rear
key : Moves cut position towards right
key : Moves cut position towards left
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Perform Test Print again for confirmation. Adjustment is
9
completed if the position of cut line is satisfactory. If not,
repeat adjustment.
Broken line is indicating the cut line
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
SETTING
F:+0.30 +0.30mm
S:-0.40 -0.40mm
[Fine Adjustment]
-
S:
Left
+/-0.3mm
Broken line is indicating the cut line
4-54
[ ] [ ]
[ ]
[ ]
-
F:
+
Center Right (Base)
+/-0.1mm