Roland SOLJET Pro III XC-540 Service Notes page 172

Confirm that the Head is certainly capped, and press the
11
[ENTER] key again. The Tool Carriage automatically
leaves the Head Carriage and it starts LIMIT POSITION
INITIALIZE.
After the completion of the INITIALIZE, the message is
indicated as shown on the right.
Move the TOOL CARRIAGE with your hand until it
12
makes full contact with the LEFT FRAME with CUT
DOWN status.
Carry out the CUT DOWN POSITION INITIALIZE by
13
pressing [ENTER] key.
After the completion of the INITIALIZE, the message is
indicated as shown on the right.
SETTING UP
DETECTING..
SETTING UP
CUTTER DOWN POS
SETTING UP
CUTTER DOWN POS
DETECTING..
INITIALIZATION
4-41
THE LIMIT
[ ]
[ ]
COMPLETED