Roland SOLJET Pro III XC-540 Service Notes page 95

Disconnect the Ink Tubes from the Ink Dampers, and
9
put the scotch tape at the tip of the Ink Tube to prevent
the ink from coming out.
Make sure not to replace the Ink Tubes of the
different colors at the same time. There is a
danger of connecting wrongly when fixing the
new ones.
Disconnect the Ink Tubes from the Joints, and put the
10
scotch tape at the tip of the Ink Tubes to prevent the ink
from coming out.
It is not necessary to replace the Ink Tubes of
the other side (Ink Cartridge side) of the Joints.
Pull out the Ink Tubes from the Cable Vayor, and put the
11
new Ink Tubes in the Cable Vayor.
Be careful which hole of the Tube Guide should
be used for each Ink Tube.
Connect the new Ink Tubes to the Joints, and mark the
12
both ends of the Ink Tubes to indicate the color of the ink.
Be careful not to forget to fix the O rings. Make
sure that the Tubes are connected firmly at the
joint part.
K
C
M
Lc
Lm
Y
C
M
3-33
Joint
< Rear view of the machine >
Joint
< Rear view of the machine >