Roland SOLJET Pro III XC-540 Service Notes page 184

From the Test Pattern, find the value where the print line
4
matches the cut line.
In this case, the correction value for the scan direction is
"-0.3".
When it is difficult to see the cut line visually,
use a magnifier.
Select [SETTING] under [PRINT-CUT ADJ.] menu and
5
enter the correction-values found in the Test Pattern for
both Feed and Scan.
F: Feed direction S: Scan direction
Left: Current value Right: New value
(Setting range: +/-5.00mm In 0.01mm unit)
key : Value of F, towards +
key : Value of F, towards -
key : Value of S, towards +
key : Value of S, towards -
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Select [TEST PRINT] under [PRINT-CUT ADJ.] menu.
6
Press [ENTER] key to start the test print.
<TEST PATTERN>
Correction-value scale
+2.0 +1.5 +1.0
-2.0 -1.5 -1.0
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
SETTING
F:+0.30 +0.30mm
S:-0.40 -0.40mm
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
TEST PRINT
4-53
+2.0 -2.0
+1.5 -1.5
+1.0 -1.0
-0.5
+0.5 -0.5
+0.0 -0.0
Scan
+0.5 +0.0
Feed
-0.5 -0.0
Cut line
[ ] [ ]
[ ]
[ ]
[ ]
[ ]