Roland SOLJET Pro III XC-540 Service Notes page 231

Starting Cutting
Print / Cut Position Adjustment
Starting Print & Cut
!! IMPORTANT !!
- Make sure the [AUTO ENV. MATCH] menu is set to ''ENABLE.''
- Before you start cutting, allow the media to dry thoroughly.
- Never use the Media Clamps when performing cutting.
- Set the value of [CALIBRATION] in [CUTTING MENU] to [0] when using the machine for printing
& cutting, because this menu is to correct the cutting length when using the machine only for
cutting.
- When you go on to cutting right after printing, the Cap of the Blade Holder may rub the printed
surface and damage the printed image.
In this case, it is necessary to extend the Blade slightly.
Crop-Cut Adjustment
Printing with Crop Marks
Alignment of the Crop Marks (Automatic)
7
!! IMPORTANT !!
Depending on the type of media, the Crop Marks on the media may not be detected
automatically. In this case, perform alignment manually.
Alignment of the Crop Marks (Manual)
Cutting Using the Crop Mark Feature
Using the Take-up System
Check with following items in reference to the Service Manual [4-16. Take-up Unit Operation Check].
Cable Connection Check for Take-up Unit.
Operating Check for Take-up Unit.
Explain following items in reference to the User's Manual [4-2. Using the Take-up System].
How to Take Up Media (when taking-up with outward curl / when taking-up with inward curl)
!! IMPORTANT !!
Avoid following operations that pull the media with undue force.
- Never operate the MANUAL switch when the loading lever is lowered.
- Never use
How to Remove Taken-up Media
to feed the media in reverse.
7-10