Roland SOLJET Pro III XC-540 Service Notes page 230

Setting the clock to the local time
- Select [SUB MENU] > [CLOCK] > [DATE] in SERVICE MENU and set the date to your local date.
- Select [SUB MENU] > [CLOCK] > [TIME] in SERVICE MENU and set the time to your local time.
Settings of the Media Heating System
- Operation of the Preheater, Print heater and DU-540 (Optional Drying-heater and Blower-fan)
- Temperature setting
- General guide for the preset temperatures
!! IMPORTANT !!
- Be cautious of the heat of the platen and dryer, and avoid fire and burns.
- Remove loaded media and switch off the sub power when not printing.
- Never use media that cannot withstand the heat of the media heating system.
- Never use the platen or dryer for unintended purpose, such as drying clothing.
Printing Tests and Cleaning
Starting Printing
Explain about the Remaining Ink
!! IMPORTANT !!
- The remaining ink amount shown on the display or RIP is an approximate guide, and not
actual amount.
Installation & Handling of the Ink Cartridges
!! IMPORTANT !!
- Gently shake the cartridge when the new ECO-SOL MAX Ink Cartridge is installed.
- Do not remove an Ink Cartridge until it runs out. If an Ink Cartridge is removed and inserted often,
air may go into the Ink tube and it may cause the Ink dropping problem.
- Be sure to replace with the same Ink type. Never mix the ECO-SOL MAX Ink with the different
Ink type.
- Insert the same type and color of Ink Cartridge into 1 to 6 and 7 to 12.
- Never allow the machine to stand with an Ink Cartridge removed. The print heads may become
clogged.
- Never store the Ink Cartridges in the location of fire or high temperature.
Performing a Cutting Test
Adjusting the Cutting Conditions
The following cutting conditions can be set by [CUT CONFIG] key.
- Blade Force
- Cutting Speed
- Blade Offset
- Tool-up Speed
!! IMPORTANT !!
Explain about [CUTTING PRIOR] as below.
[MENU]... Cuts with the cutting conditions set on the machine.
[COMMAND]... Cuts with the cutting conditions set on the Roland VersaWorks.
7-9
7