Roland SOLJET Pro III XC-540 Service Notes page 136

Remove all cartridges
before pressing ENTER
CARTRIDGE
I/S MENU
CARTRIDGE IC CHECK
CARTRIDGE
SLOT 1
CARTRIDGE
SLOT 2
CARTRIDGE
SLOT 12
Set cartridge to SLOT1
IC CHECK
SLOT1 INSERT
Error
IC CHECK
SLOT1 ERROR
Normal
IC CHECK
SLOT1 OK
From SLOT1 to 12 in order
Set cartridge to SLOT12
IC CHECK
SLOT12 INSERT
Error
IC CHECK
SLOT12 ERROR
Normal
IC CHECK
SLOT12 OK
IC CHECK
COMPLETED
SL1 : SERIAL
Serial No. of the Ink Cartridge IC is displayed.
1402A30C010000A5
SL1 : INK TYPE
Ink type of the Ink Cartridge IC is displayed.
Max K
SL1 : CAPACITY
Ink capacity of the Ink Cartridge IC is displayed.
400cc
SL1 : LOT NO.
Lot No. of the Ink Cartridge IC is displayed.
40216A
SL1 : CONSUM.
Ink consumption of the Ink Cartridge is displayed.
100.000cc
SL1 : TIME
The used time of the Ink Cartridge is displayed.
0y000d00h00m00s
SL1 : INSERT
The insert count of the Ink Cartridge is displayed.
1 times
SL1 : FLAG
The Flag information of the Ink Cartridge is displayed.
000000000
It reads the information written on the IC of each carriage.
Following messages are displayed when some error is found.
Ink cartridge is not inserted
SLOT1
NO CARTRIDGE
A cartridge with no IC is inserted, wire break or short
SLOT1
NO IC CHIP
System error due to the trouble such as a damage of driver IC placed on INK TANK BOARD
SLOT1
SYSTEM ERROR
Data error
SLOT1
DATA ERROR
4-5
All cartridges must be removed before entering IC
CHECK menu.
It detects Ink Cartridge IC, writes and loads information,
and checks the communication. First of all, it confirms
if there is the driver for IC detection. The following
display indicates that error is found on driver.
IC CHECK
SYSTEM ERROR
Next, IC communication is checked individually by SLOT.
When a cartridge is inserted, it automatically starts to
communicate with the cartridge IC and checks it. Display
shows [OK], when the communication is done properly.
As cartridge is removed, the next cartridge SLOT number
to be inserted is displayed. Starting from SLOT1, it
continues to SLOT12 in order. When the check of
SLOT12 is completed, the following message is
displayed at the end of check.
IC CHECK
COMPLETED
It returns to IC CHECK menu by pressing ENTER key.
When communication is failed, it displays as below.
IC CHECK
SLOT1 ERROR
It returns to IC CHECK menu by pressing ENTER key.
*Any cartridge can be used for this check as long as it
has IC chip on it.
*No information is written on IC chip during this check.
(Normally, the count of the cartridge installation is
written. However, the count of the installation in this
check is not written.)
*Before this IC check, make sure Cartridge Sensor is
working properly.