Roland SOLJET Pro III XC-540 Service Notes page 70

If you dispose of the drained ink when performing [PUMP
U P ] a t 2
[MAINTENANCE] >[DRAIN BOTTLE] >[EMPTY DRAIN
BOTTLE] > [RESET DRAIN COUNTER] in the User's
menu, and press the [ENTER] key to reset the drain
counter.
Enter the Service Mode and perform the following adjustments.
20
1. THERMISTOR CHECK
2. [4-5 HEAD ALIGNMENT]
3. HEAD INFORMATION CLEAR
4. [4-8 CAP HEIGHT ADJUSTMENT]
5. [4-10 CROP-CUT ADJUSTMENT]
6. [4-11 PRINT / CUT POSITION ADJUSTMENT]
HOW TO CLEAR THE HEAD INFORMATION
After THERMISTOR CHECK and HEAD ALIGNMENT,
clear the HEAD INFORMATION from the [SERVICE
MENU] > [HISTORY MENU] > [HEAD GROUP]. Select
the Head you replaced and press the [ENTER] key.
* The Head No. becomes [HEAD 1], [HEAD 2], [HEAD 3]
from the Head at the left end in order.
< Note for fixing the Carriage Cover >
Fix the Carriage Cover with the 4 screws shown in the figure
temporarily. And tighten them without distorting the Cover.
Be careful not to distort the Carriage Cover when
tightening the 2 front screws.
The Carriage is distorted and the Head position may
shift.
, s e l e c t [ S U B M E N U ] >
EMPTY
RESET DRAIN
SERVICE MENU
HISTORY MENU
[
HISTORY MENU
HEAD GROUP
[
Carriage Cover
Screw
3-8
SUB MENU
SUB MENU
MAINTENANCE
MAINTENANCE
DRAIN BOTTLE
DRAIN BOTTLE
COUNTER
]
HEAD GROUP
CLEAR ALL
[ ]
] [ ]
HEAD GROUP
CLEAR H6
[ ]
HEAD GROUP
CLEAR H5
[ ]
HEAD GROUP
CLEAR H4
[ ]
HEAD GROUP
CLEAR H3
[ ]
HEAD GROUP
CLEAR H2
[ ]
HEAD GROUP
CLEAR H1