2.
Loosen the Screw half around to make a gap
between the Stay and Shaft.
Tighten the Adjustment Screw to have tension on the
12
Belt. And tighten the 2 Fixingscrews as shown in the
figure.
Do not tighten the Screws too hard.
After turning on the Main Power SW, turn on the Sub
13
Power SW while pressing the Left, Right and Down keys
to enter the Service Mode.
Select [I/S MENU] > [I/S CONTROL] > [CAP] >
14
[CLOSE], and press the [ENTER] key. The Capping Unit
moves up. Press the [ENTER] key 3 times, because the
Capping Unit moves up in 3 steps.
Screw
Adjustment Screw
[ ], [ ], [ ] + SUB POWER ON
MENU
SERVICE MENU
SERVICE MENU
I/S MENU
I/S MENU
I/S CONTROL
I/S CONTROL
CAP
CAP
CLOSE
3-56
< Top view - Leftside of the Belt >
FIxingscrew
[MENU] key
[
]
[
]
[
]
[
]
[
] [
]