Pinch Roller Replacement - Roland SOLJET Pro III XC-540 Service Notes

3-13 PINCH ROLLER REPLACEMENT

Conical Type is used on both Left & Right Pinch Rollers
1
and flat type is used for the Middle Pinch Rollers.
Red marking is done on the outer side of
Left & Right Pinch Rollers so that .
Remove the E ring on one side if the Pinch Roller and pull
2
out the Shaft.
Replace the Washers on a paper not to
lose them which are fixed at both sides of
the Pinch Roller.
Put the new Pinch Roller with Washers and put the Shaft
3
into the Pinch Roller.
Fixing operation becomes easy when you put the
Washers to the Pinch Roller with grease.
Fix the E ring and make sure that the Pinch Roller
4
rotates smoothly.
Left Pinch Roller
Pinch Roller
Washer
3-67
Right Pinch Roller
Red marking
E ring
Shaft
E ring