Roland SOLJET Pro III XC-540 Service Notes page 134

PRINT MENU
LINEAR ENCODER
This menu is for checking the installation and operation of Encoder Module and Encoder Scale.
Refer to [4-7 LINEAR ENCODER SETUP].
PRINT MENU
LINEAR CALIB.
This menu is used for calibrating the Encoder Scale. Refer to [4-7 LINEAR ENCODER SETUP].
PRINT MENU
CALIB.DEFAULT
PRINT MENU
DOUBLED HEADS
PRINT MENU
TEST PATTERN
NOW PROCESSING..
POS: 1361.00mm
NOW PROCESSING..
CALIB.DEFAULT
TEST PRINT
CALIB.DEFAULT
SETTING
DOUBLED HEADS
This menu is displayed only when the Ink Type is Max 2MC.
This is for specifying the MC head combination to be disabled under the
HEAD 1&2 5&6
situation when the Ink Type is Max 2MC and printing in non-high-speed
mode using 4heads.
This setting is active only when ALTERNATE HEAD is DISABLED in the
user menu.
TEST PATTERN
HORIZONTAL
TEST PATTERN
BI-DIR
TEST PATTERN
FILL
TEST PATTERN
BI-DIR. CHECK
4-3
Normal (beeps 1 time)
LINEAR ENCODER
SETUP COMPLETED
Error (beeps 2 times)
LINEAR ENCODER
Error is found on Linear
Encoder and Scale.
SETUP FAILED
Error is found on
LINEAR ENCODER
Head Board.
HEADBOARD FAILED
Normal (beeps 1 time)
LINEAR CALIB.
SETUP COMPLETED
LINEAR CALIB.
0.18%
Error (beeps 2 times)
LINEAR CALIB.
FAILED TO SETUP
PERFORMING
This menu is used for Calibration.
Refer to [4-12 CALIBRATION (FE-
TEST PRINT
EDING DIRECTION)].
When it shows [
SETTING
that it has never been setup and it
needs to be set. In this case, even if
+0.05% +0.10%
adjustment is unnecessary by the
test result, it needs to be set with [0].
Options: 1&2, 5&6
PERFORMING
It is for checking the Head
Alignment in Horizontal.
TEST PRINT
PERFORMING
It is for checking the Head
Alignment in Bidirection.
TEST PRINT
PERFORMING
It prints on the entire print range
solid in single color by each head.
TEST PRINT
Print mode is fixed at 720 dps and
8 pass.
PERFORMING This print pattern is for checking a
shifting error in Bidirection and also
TEST PRINT
for confirming the mechanical
tendency.
], it means
Default: 5&6