Roland SOLJET Pro III XC-540 Service Notes page 238

*1
The length of printing or cutting is subject to the limitations of the program or driver.
*2
At Roland PET film, print travel: 1 m
Temperature: 25 C (77 F), humidity: 50%
*3
Not assured when the print heater or dryer is used.
*4
The following conditions must be met:
Media type: Media specified by Roland DG Corp.
Roll media must be loaded on the shaft.
[PREFEED] menu item must be set to "ENABLE."
Side margins: 25 mm or more for both the left and right margins
Front margin: 35 mm or more
Excluding stretching/contraction of the media
Range for assured repetition accuracy
For media with a width exceeding 610 mm: Length 4,000 mm
For media with a width of 610 mm or less: Length 8,000 mm
*5
Provided that media length is under 3000 mm
Temperature: 25 C (77 F)
Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*6
Media type : Roland PET film
Data size: 1,000 mm in the media-feed direction, 1,346 mm in the carriage-movement direction.
No lamination
Automatic detection of crop marks at 4 points when media is reloaded.
During cutting, [PREFEED] menu item must be set to "ENABLE."
Temperature: 25 C (77 F)
Excludes the effects of slanted movement and of expansion and contraction of the media.
*7
Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating environment.
Depending on the ambient temperature and media width, the preset temperature fail to be reached.
*8
Operating environment
(%)
Humidity
(no condensation)
80
55
35
0 15 20 27 32
(59) (68) (80.6)
Temperature
Use in an operating environment with
this range.
C ( F)
(89.6)
7-17
7