Roland SOLJET Pro III XC-540 Service Notes page 182

A mark is printed, and detected by the crop mark sensor,
7
and its contour is cut. Confirm the cut line position on the
print visually.
When it is difficult to see the cut line visually,
use a magnifier.
Adjustment is completed if the position error of cut line is
8
within +/-0.1mm. If not, select [SETTING] menu again for
further adjustment.
key : Moves cut position towards front
key : Moves cut position towards rear
key : Moves cut position towards right
key : Moves cut position towards left
ENTER key : Saves new setting
MENU key : Moves out SETTING menu
Perform Test Print again for confirmation. Adjustment is
9
completed if the position of cut line is satisfactory. If not,
make an adjustment again.
Broken line is indicating the cut line
CUTTING MENU
CROP-CUT ADJ.
CROP-CUT ADJ.
SETTING
F:+0.30 +0.30mm
S:-0.40 -0.40mm
[Fine Adjustment]
-
S:
Broken line is indicating the cut line
Before adjustment
4-51
[ ] [ ]
[ ]
[ ]
-
F:
+
After adjustment