Roland SOLJET Pro III XC-540 Service Notes page 200

Press [ENTER] key to cancel AGING.
13
Loosen the two fixing screws located at the left end of
14
the belt eighth to quarter round.
When the screw is loosen more than
necessary, it gives difficulty in adjusting the
belt.
Also, you need to be cautious with the
sharp edges around it when turning the
screws. It may cause injury.
Insert a wrench through the holes on the side frame
15
prepared for the adjustment, and loosen the two screws
to make a gap of 3mm between the tip of the screw and
Idle Pulley Holder.
The gap between the screws and Idle Pulley
can be seen from both front side and rear
side of the machine.
Press [ENTER] key to restart AGING.
16
SCAN
NOW AGING
SCREW
AGING
SCAN
4-69
[ ]
FIXING SCREW
3mm
IDLE PULLEY HOLDER
[ ]