Roland SOLJET Pro III XC-540 Service Notes page 163

- When the lines other than K are above the K lines, turn
the Adjustment Screw CW.
- When the lines other than K are below the K lines, turn
the Adjustment Screw CCW.
Adjust the Head positions refering to the left-
end K head as the base position. The position
of K head on the left end does not need to be
adjusted.
Tighten the screws fixing the Head in the order reverse of
15
loosening, using the TORQUE DRIVER (ST-056).
Torque for tightening is 2kgf • cm (20cNm).
Make sure not to tighten the screws firmly.
Print the test pattern again.
16
If the result is not satisfactory, repeat 11 to 15 .
The shifting of lines should be less than 1/2 dot.
4-32
2
3
1