Replacing The Tec 01 - Christie HS 2K Series Service Manual

5. Remove the I/O board
See Removing the I/O board
6. Remove the thermal switch harnesses from clips.
7. Remove two M3 screws with a Phillips #1 screwdriver.
8. Replace the thermal switch.
9. To re-install, follow these steps in reverse order.

Replacing the TEC 01

The TEC 01 provides thermal cooling to the DMD Chip.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board module.
See Replacing the main board
3. Remove the main board bottom shielding.
See Removing the rear cover
4. Remove the rear cover.
See Removing the rear cover
5. Remove the front cover.
See Removing the front cover
6. Remove the left-side cover.
See Removing the left-side cover
7. Remove the right-side cover.
See Removing the right-side cover
8. Remove the laser driver board.
See Replacing the blue 1 and 2 laser driver board
driver board on page 102.
9. Remove the DMD cold plate.
See Replacing the light engine
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 99.
on page 59.
on page 94.
on page 59.
on page 59.
on page 61.
on page 63.
on page 62.
on page 85.
on page 100, Replacing the red laser
Electronics
81