Replacing The Combiner Module - Christie DHD410S Service Manual

See Replacing the DMD board
11. To release the DMD, rotate the lock screw counterclockwise by a Flathead screwdriver.
12. Replace the DMD.
When replacing the DMD module ensure that the new thermal pad is applied evenly.
13. To re-install, follow these steps in reverse order.

Replacing the combiner module

Replacing the combiner must be done in a clean room.
To remove the combiner module, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board.
See
Replacing the main board
3. Unplug one connector from laser driver board.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 83.
on page 46.
on page 77.
Optics
64