Replacing The Remote Temperature Sensor Module; Removing The Low Profile Extractor - Christie Roadie 4K35 Service Manual

Replacing the remote temperature sensor module

Temperature sensor locations:
• Integrator
• Lamp exhaust
• Prism
• Each DMD
• Fan card cage
Estimated Replacement Time: 3 minutes +
Lamp exhaust temperature sensor module estimate time: 8 minutes + 10 minutes lamp calibration
1. Remove the front top lid (on page 40).
2. If removing the lamp exhaust sensor module:
a) Remove the rear top lid (on page 42).
b) Remove the lamp (on page 60).
3. Disconnect the harness from the required remote temperature sensor module (RTSM).
4. If removing the lamp exhaust temperature sensor module, remove the eight screws securing
the exhaust blower cover.
5. Remove the one screw securing the RTSM.
6. To install the RTSM, repeat these steps in reverse order.

Removing the low profile extractor

Estimated replacement time: 10 minutes
1. Remove the front top lid (on page 40).
2. Remove the rear top lid (on page 42).
3. Remove the eight screws.
4. Release the brown blower L cable, blue blower N cable, and ground cable from the terminal
block and ground stud.
5. Remove the lower profile extractor.
6. To install the low profile extractor, repeat these steps in reverse order.
Roadie 4K35 and 4K45 Service Manual
020-101694-03 Rev. 1 (01-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Parts and module replacement
58