Replacing A Projector's Foot - Christie GS Series Service Manual

12. Remove the 19 M3 screws with a Phillips #1 screwdriver securing the bottom cover.
13. If required, replace the bottom cover.
14. To re-install, follow these steps in reverse order.

Replacing a projector's foot

The adjustable feet can be raised or lowered when positioning the projector to make sure it is level
on all sides so the displayed image appears rectangular without any keystone.
1. Ensure the projector is in a secure position.
Christie does not recommend having the projector overhang when replacing the feet, unless the
projector is securely positioned.
2. Remove the top cover.
See Removing the top cover
3. Remove the main board and I/O board.
See Replacing the main board and I/O board
4. Remove the front cover.
See Removing the front cover
5. Remove the rear cover.
See Removing the rear cover
6. Unlock the three nuts with a M6 socket driver.
7. Loosen the screw and remove the foot.
8. Replace the foot.
9. Repeat steps 2 and 7 for any additional feet that need to be replaced.
10. To re-install, follow these steps in reverse order.
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 63.
on page 83.
on page 65.
on page 64.
Elevator foot
Projector covers and feet
69