Replacing A Projector's Foot - Christie CP2208-LP Service Manual

Replacing a projector's foot

The adjustable feet can be raised or lowered when positioning the projector to make sure it is level on
all sides so the displayed image appears rectangular without any keystone.
Estimated replacement time: 9 minutes for the front feet and 15 minutes for the rear feet.
1. Turn off the light and cool the projector for at least 15 minutes.
2. When the cooling fans stop, turn the projector off and disconnect it from AC power.
3. Prop up the appropriate end of the projector, or shift the projector off of the table or pedestal
to create enough clearance.
To remove the front feet, 15 cm (6 in.) of clearance is required. To remove the rear feet, 23
cm (9 in.) of clearance is required.
4. To remove the rear feet, Remove the rear skin (on page 37) or to remove the front feet,
remove the front skin (on page 33).
5. Hold the foot with a ratchet (A) and turn the top locking nut (B) to remove it.
6. Remove the foot.
7. To install the new foot, repeat these steps in the reverse order.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Projector covers and feet
41