Removing The Front Cover; Removing The Front Feet - Christie M Series Service Manual

8. To install the intake side panel, complete these steps in reverse order.

Removing the front cover

Removing the front cover allows access to the yellow notch filter assembly (YNF), dynamic iris
assembly and the light sensor module. The front cover is held by two screws under the top cover
located in the corners and three screws along the lower portion of the front cover.
The infrared PCB is located on the inside of the front cover and is connected by one wire to the panel
driver.
Estimated replacement time: 5 minutes.
1. Remove the lens (on page 76).
2. Remove the top cover (on page 45).
3. Disconnect the front IR harness P108 from the IR PCB (J108).
When reconnecting, remove the two screws from the IR PCB, reconnect the harness, and
reinstall the IR PCB onto the front cover.
4. Remove the two screws located in each corner under the top cover.
5. Remove the three screws located along the bottom of the front cover.
6. Remove the front cover.
7. To install the front cover, complete these steps in reverse order.

Removing the front feet

Complete the following procedure to remove the front feet.
Estimated replacement time: 10 minutes.
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Projector covers and feet
48