Removing The Front Cover; Removing The Right-Side Cover - Christie GS Series Service Manual

11. To re-install, follow these steps in reverse order.

Removing the front cover

The front cover provides access to the lens assembly and front IR sensors.
1. Remove the top cover.
See Removing the top cover
2. Remove the LED board.
See Replacing the LED board
3. Loosen the six captive M3 screws with a Phillips #1 screwdriver securing the front cover
module.
4. Remove the two M3 screws with a Phillips #1 screwdriver securing the LED holder.
5. Remove the front IR sensor board.
See Replacing the front IR sensor board
6. Transfer the IR sensor board and LED board to the new front cover.
7. If required, replace the front cover.
8. To re-install, follow these steps in reverse order.

Removing the right-side cover

The right-side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 63.
on page 89.
on page 88.
on page 63.
on page 83.
Projector covers and feet
65