Kemper EVOLUTION LINE Operating Manual page 87

Description of the line
In the 'Cutting station' sub-menu you can change the data for controlling the cutting
station by touching the input boxes:
O
PTION
C
UTTING
STATION
C
ENTERING
UNIT
In the 'Knife running time' submenu you can compensate for the triangular knife's different
running times during the outward and return strokes. Password level 1 is required for this
input.
A -
NTI
CLOCKWISE
DRIVE
C
LOCKWISE
DRIVE
Emil Kemper GmbH
11:27:35
14000 pcs/h
Cutting station
Option
Cutting station
Centering unit
Stop
Start
Selection of 'Auto' or 'Manual'. 'Auto' means that the cutting station starts to
run when the first dough pieces arrive. 'Manual' means that the cutting
station runs constantly.
'On' or 'Off' in the 'Cutting station' box causes the line module to be
switched on or off.
A value between 5 and 200 pulses can be entered in the 'Centering unit'
box to set the timing.
An input between 100 and 200 milliseconds to compensate for the
triangular knife's different running times.
An input between 100 and 200 milliseconds to compensate for the
triangular knife's different running times.
EVOLUTION LINE roll machine
Head machine
Knife running time
Auto
(Specified air pressure
is 5 bar)
Off
Anti-clock.drive
0 Ip
Clockwise drive
Line
1
0
0
msec.
msec.
0
79