Kemper EVOLUTION LINE Operating Manual page 145

Operation

Touch the N
A keypad appears for entering numbers.

Enter the number of trays on the pull-out table.

Touch the R
A keypad appears for entering numbers.

Enter the number of dough piece rows on the wooden tray/baking tray.

Touch the S
A keypad appears for entering numbers.

Enter the start time in pulses for the reciprocating belt's step between depositing
patterns.

Touch the D
A keypad appears for entering numbers.

Enter a correction value in millimetres per piece if the calculated speed for control of
depositing is not correct.

Under S
A keypad appears for entering numbers.
The respective step length is listed for each tray (wooden trays/baking trays) below the
S
TEP LENGTH

Enter a new step length in millimetres if you want to change the step length of the
respective tray (wooden trays/baking trays).
Emil Kemper GmbH
input box (4).
UMBER OF TRAYS
(
OWS LONGITUDINAL
input box (6).
TEP CORRECTION
EPOSITING CORRECTION
[ ] (8), touch an input box of your choice.
TEP LENGTH MM
[ ] input box.
MM
EVOLUTION LINE roll machine
) input box (5).
input box (7).
137