Structural Alterations To The Line; Cleaning And Waste Disposal; Obligations Of The Plant Operator - Kemper EVOLUTION LINE Operating Manual

Introduction

1.6 Structural alterations to the line

Construction and acceptance at the plant are based on the German Equipment and
–
Product Safety Act (GPSG).
No alterations, additions or conversions are allowed to be made to the line without
–
prior written permission from Emil Kemper GmbH.
Any breach of this causes the line to lose its EC conformity. Such a breach absolves
the manufacturer of the line from warranty.
This also applies to welding work on load-bearing parts.
Any parts not in a perfect state must be replaced immediately.
–
Use original spare parts only. Only they satisfy the technical requirements.
–

1.7 Cleaning and waste disposal

Materials used to clean the line must be handled and disposed of properly.
–
National rules must be obeyed, especially when working on lubrication systems and
devices and cleaning with solvents.
All parts of the electrical installations must be protected from moisture, humidity and
–
dust.
Before all cleaning work on the line shut off electrical power to the line and prevent the
–
main switch from being switched on again unexpectedly.
Cleaning during operation is strictly prohibited. There is an increased risk of injury if
–
this is done.
The cleaning personnel must have read and understood the operating manual before
–
cleaning.
The safety information and cleaning intervals must be followed (see chapter "8
–
Cleaning and maintenance").

1.8 Obligations of the plant operator

The plant operator undertakes to only let personnel work at the line who
are familar with the basic rules concerning safety at work and accident prevention,
–
have been instructed in handling the line,
have read and understood this operating manual (especially the safety information)
–
and have confirmed this with their signatures.
The safety awareness of personnel will be checked at regular intervals.
Emil Kemper GmbH EVOLUTION LINE roll machine
7