Setting The Reciprocating Belt; Setting The Wooden Tray Stop; Setting A Recipe At The Reciprocating Belt - Kemper EVOLUTION LINE Operating Manual

Operation

7.4.13 Setting the reciprocating belt

Configuration of the line module Reciprocating belt in the line is displayed in section
"5 Overview of the line".

7.4.13.1 Setting the wooden tray stop

7.4.13.2 Setting a recipe at the reciprocating belt

This section describes all the necessary working steps to carry out changes to your
recipes at the line module reciprocating belt.

Switch the line on (see section "7.1 Switching the line on and off").

Switch the control voltage on (see section "7.2 Switching the control voltage on").

Open the desired recipe (see section "7.5 Selecting a recipe via the touch panel").
After a few seconds, the start screen appears with illustrations of the line's assemblies on
the touch screen. See section below:
Emil Kemper GmbH
Note!
The touch control contains recipes which have been set by Emil Kemper
GmbH according to your wishes.
EVOLUTION LINE roll machine
Loosen the arrester wheel (1).
Move the stop bar (2) to the required position.
Retighten the arrester wheel (1).
129