Removing The Thrust Unit - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Main Units > Removing the Thrust Unit

Removing the Thrust Unit

3) Remove the 6 screws and then remove the PCB cover.
1) Remove the saddle cover.
(Refer to page 4-22）
2) Pull out the saddle unit to
the service position.
（Refer to page 4-32）
4) Disconnect the 16 connectors and release the harness from
the harness guide.
x16
4 Parts Replacement and Cleaning Procedure > Main Units > Removing the Thrust Unit
F-4-77 F-4-77
5) Release the harness from the wire saddles and disconnect the 2 connectors.
x2
x6
F-4-78 F-4-78
4-37
F-4-79 F-4-79
4-37