Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Paper Holding Torque Limiter
4) Disconnect the connector and remove the 2 screws, and then remove the stapler unit.
x2
Removing the Paper Holding Torque Limiter
2) Remove the 2 screws and open the finisher controller
1) Remove the rear cover
(upper).
PCB mount.
(Refer to page 4-19)
x2
4
Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Paper Holding Torque Limiter
x2
F-4-89
3) Pull out the pin and remove the paper holding torque limiter.