Adjusting The Position Attached The Saddle Inlet Flapper Solenoid (Sl206); Note On Replacing The Finisher Controller Pcb - Canon Staple Finisher-D1 Service Manual

5
Adjustment > Action on parts replacement > Note on replacing the finisher controller PCB
Adjusting the position attached the Saddle Inlet Flapper
Solenoid (SL206)
CAUTION:
When attaching the saddle inlet flapper solenoid (SL206), adjust the
position attached the solenoid.
1) Loosen the screw.
2) Lower the arm of the saddle inlet flapper until it stops. Then, shift the position of the
solenoid so that the arm bumps against the link when pushing the plunger of the
solenoid.
3) Tighten the screw.
0mm
5 Adjustment > Action on parts replacement > Note on replacing the finisher controller PCB

Note on replacing the finisher controller PCB

1) Before replacing the finisher controller PCB, store the adjustment values and the
counter of the consumable parts to the host machine.
2) After replacing the finisher controller PCB, write the stored data to the new finisher
controller PCB by the service mode of the host machine.
(Refer to the service manual for the host machine as to the datail.)
If the adjustment values cannot store to the host machine, enter the values on the
service label that attached to the PCB cover by the service mode after replacing the
finisher controller PCB. However, in this case, the counter cannot enter.
F-5-18 F-5-18
5-10
F-5-19 F-5-19
5-10