Canon Staple Finisher-D1 Service Manual page 187

3) Using the wrench, turn the caster lock nut in the direction of the arrow to
loosen the nut.
4) Using the wrench, turn the height adjusting nut of the caster in the direction of the arrow.
(A full turn of the adjusting nut changes the finisher height by 1.75 mm.)
- To increase the height of the finisher, turn the nut in the direction of arrow [A].
- To decrease the height of the finisher, turn the nut in the direction of arrow [B].
[A]
[A]
[B]
6
Installation > Making Adjustments > Adjusting the Height and Tilt > Adjusting the Height and Tilt
F-6-87 F-6-87
[B]
F-6-88 F-6-88
6
Installation > Making Adjustments > Adjusting the Height and Tilt > Adjusting the Height and Tilt
MEMO:
Adjust the height at four casters.
F-6-89 F-6-89
6-34
6-34