Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Torque Limiter (Tray1/2 Paper Holder)
Removing the Torque Limiter (Tray1/2 Paper Holder)
1) Remove the grated-
2) Take off the 3 belts from the pulleys.
shaped upper guide.
(Refer to page 4-23)
4) Remove the 4 clips and slide the 4 bushings, then remove the
paper holder shaft units.
4
Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Torque Limiter (Tray1/2 Paper Holder)
3) Remove the 2 screws and then remove the paper holder shaft plates
(front) and (left).
F-4-117
5) Remove the 2 torque limiters (tray1/2 paper holder).