Removing The Front Alignment Motor (M108) - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Motors > Removing the Front Alignment Motor (M108)
4) Open the edge saddles, remove the 2 screws and then
take out the motor mount.

Removing the Front Alignment Motor (M108)

2) Remove the clip and pulley. Remove the E ring, gear, pulley, torque limiter, 2
1) Remove the processing
straight pins, and then free the belt from the shaft.
tray unit.
(Refer to page 4-30)
4
Parts Replacement and Cleaning Procedure > Motors > Removing the Front Alignment Motor (M108)
5) Disconnect the connector, remove the 2 screws and then
the rear alignment motor.
F-4-141
F-4-142
F-4-143
4-61
4-61