Canon Staple Finisher-D1 Service Manual page 189

6
Making Checks after Completion of Adjustments
1) Check to see that the difference in height between the finisher and the upstream connection machine and the tilt are within the specifications. If they are not within the specifications, make
adjustments again with reference to Section "Adjusting the Height and Tilt".
2) After making adjustments, attach the wrench to the back of the front cover and then close the front cover.
6
Installation > Making Adjustments > Making Checks after Completion of Adjustments
Installation > Making Adjustments > Making Checks after Completion of Adjustments
6-36
6-36