Canon Staple Finisher-D1 Service Manual page 184

MEMO:
As for the difference in rear height between the finisher and the document insertion unit, make
sure that it is within 139±2mm, or as for the difference in rear height between the finisher and
the paper folding unit, make sure that it is within 150±2mm.
2) Check the relational tilting amount of the finisher for the upstream connection machine. Make sure that the gap between the right side
of the finisher and the left side of the upstream connection machine is 3±1.5 mm.
6
Installation > Making Adjustments > Adjusting the Height and Tilt > Checking the Difference in Height and the Tilt
139±2mm : For Document Insertion Unit
150±2mm : For Paper Folding Unit
3±1.5mm
3±1.5mm
3±1.5mm
6
Installation > Making Adjustments > Adjusting the Height and Tilt > Checking the Difference in Height and the Tilt
F-6-81 F-6-81
3) If the height and tilt of the finisher
must be adjusted, go to "Adjusting
the Height and Tilt".
F-6-82 F-6-82
6-31
6-31