Removing The Swing Unit - Canon Staple Finisher-AA1 Service Manual

■ Procedure
1. Remove the grate-shaped lower guide.
• 2 screws [2]
2x
[2]
CAUTION:
Insert the claw[1] as shown in the figure for installation
and then hook the rack[2] on the stepped screw.

Removing the Swing Unit

■ Preparation
1. Lower the stack tray.
[1]
2. Remove the front cover.
" Removing the Front Cover" on page 94
3. Remove the front inner cover.
" Removing the Front Inner Cover" on page 95
4. Remove the rear cover.
" Removing the Rear Cover" on page 94
5. Remove the escape tray.
"Removing the Escape Tray" on page 96
6. Remove the grate-shaped guide.
"Removing the Grate-shaped Guide" on page 131
■ Procedure
NOTE:
An image of removing of swing unit
97
4. Parts Replacement and Cleaning