Clutchs/Solenoids; Removing The Saddle Inlet Flapper Solenoid (Sl206) - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Clutchs/Solenoids > Removing the Saddle Inlet Flapper Solenoid (SL206)

Clutchs/Solenoids

Removing the Saddle Inlet Flapper Solenoid (SL206)

2) Put a mark on the fixed position of the solenoid. Release the
1) Remove the rear cover
solenoid harness from the wire saddle and disconnect the
(upper).
connector. Remove the screw and then remove the saddle inlet
(Refer to page 4-19)
flapper solenoid.
4 Parts Replacement and Cleaning Procedure > Clutchs/Solenoids > Removing the Saddle Inlet Flapper Solenoid (SL206)
F-4-128
4-55
4-55