Staple Operation - Canon Staple Finisher-D1 Service Manual

2
Technology > Processing Tray Unit > Staple Operation

Staple Operation

Sheets are stapled after being fed to the processing tray and aligned there.
2 Technology > Processing Tray Unit > Staple Operation
Stapler
F-2-29 F-2-29
Stapling and alignment positions in different staple modes are as follows:
<Front 1-Point Stapling>
Alignment position: Sheets are aligned to the center when the paper width is more than 216
mm. Sheets are aligned to the position 15 mm frontward from the center when the paper
width is 216 mm or less.
Alignment Plate (rear)
Feed direction
Alignment plate (front)
2-19
Stopper
Staple position
F-2-30 F-2-30
2-19