Removing The Sub Guide Torque Limiter - Canon Staple Finisher-D1 Service Manual

4
Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Sub Guide Torque Limiter

Removing the Sub Guide Torque Limiter

1) Remove the grate- 2) Remove the 2 clips and shift the 2 bushings to the outside.
shaped lower guide.
(Refer to page 4-26)
3) Release the drive shaft from the belt and remove it.
4 Parts Replacement and Cleaning Procedure > Consumable Parts Requiring Periodic Replacement and Cleaning Points > Removing the Sub Guide Torque Limiter
4) Remove the E-rings and the straight pins, and then remove the torque limiters.
F-4-110
F-4-111
F-4-109
F-4-112
4-47
4-47