Shift Operation - Canon Staple Finisher-D1 Service Manual

2
Technology > Processing Tray Unit > Shift Operation
5) The front/rear alignment motor (M108/M109) is driven to move the alignment plate (front/
rear), thus aligning the sheets stacked in the processing tray. This operation is performed
each time paper is fed to the processing tray.
Alignment Plate
2 Technology > Processing Tray Unit > Shift Operation

Shift Operation

Sheets fed to the processing tray are aligned to the front or rear using the alignment plates.
Alignment positions are as follows:
Front alignment: 15 mm frontward from the center
Rear alignment: 15 mm rearward from the center
F-2-27 F-2-27
Alignment Plate (rear)
Paper
Shifted 15 mm frontward
from the feed unit centerline.
Stacking Tray Alignment Plate (front)
Alignment Plate (rear)
Shifted 15 mm rearward
from the feed unit centerline.
Paper
Stacking Tray Alignment Plate (front)
2-18
F-2-28 F-2-28
2-18